Mounting on steel without drilling or welding – how industry solves it in practice

In heavy industry, wind & energy and oil & gas, the same challenge comes up again and again:

You need to mount equipment on steel surfaces – quickly, safely and without affecting the structure.

Traditional methods create real problems in practice:

🚫 drilling takes time and can weaken the structure
🚫 welding is permanent and requires preparation
🚫 temporary solutions are often unstable

This applies across construction sites, ports, offshore installations and energy projects.

 
A more flexible approach
Instead of permanent modifications, more companies are choosing solutions that can adapt over time.

V-MAG industrial magnets allow you to mount directly onto steel – with no tools, no modifications and no waiting time.

Place the magnet – and the installation is ready.

 
It’s not about the magnet
In practice, it’s not about the product itself – it’s about what you save:

✅ faster installation → reduced downtime
✅ no permanent changes → full flexibility
✅ easy repositioning → adapt during operation
✅ no surface damage → lower maintenance

In environments where setups change daily, flexibility is not a benefit – it’s a necessity.

 
Typical applications
The solution is widely used across industries, especially for:

👉 cables and temporary installations
👉 work lights and floodlights
👉 sensors and measurement equipment
👉 cameras and surveillance
👉 smaller technical components

It is particularly relevant when the installation is not meant to be permanent.

 
In wind & energy and oil & gas
In the energy sector, the requirements are even higher:

👉 temporary setups during installation and service
👉 cable routing on containers and technical units
👉 mounting without damaging coating or certifications

Here, the ability to work quickly – without permanent modifications – is critical.

 
Choosing the right magnet
Typically, the choice comes down to two levels:

• 70 kg pull force – for lighter installations
375 DKK excl. VAT

• 340 kg pull force – for heavier equipment and demanding environments
535 DKK excl. VAT

The right choice depends on load, safety requirements and surface conditions.

 
📞 +45 22 66 46 38
📧 info@specialcontainer.dk
🛒 www.specialcontainer.dk